• Not been the best of weekends, bike-wise

    From PipL@pip@nowhere.nul to uk.rec.motorcycles on Sun Nov 1 16:49:03 2026
    From Newsgroup: uk.rec.motorcycles

    Part the first.

    After patching the Guzzi's rear wheel last week, I noticed that it was
    still losing a pound or two per day, so I left it to the weekend to have
    a look.

    The pressure was down 10 psi.

    The patch wasn't leaking! The valve was tight. The metallic looking
    thing in the tread turned out to be a tiny pebble of no consequence.

    Unfortunately, there was another fucking hole barely 20 mm from the
    first. I think that two patches so close to each other means a new tyre.

    Part the second.

    As my visor is getting a little old and because the Pinlock insert,
    though it worked pretty well generally, never fully sealed and water
    would sometime trickle down inside it, plus in severe conditions it
    would fog between layers. It's also getting on a bit.

    On the spur of the moment, I ordered a Visin electric visor kit.

    Today I fitted it. I made sure the brand new visor I'd bought was the
    right one. I checked the insert against the controller - green lights. I
    read the instructions, watched the video, fitted the template carefully, practiced fitting the insert, fitted it and... the fucking controller
    shows a fault.

    The only possible thing I can think of is that just before fitting it, I carefully peeled a couple of inches of the inner protective film back to
    look through and check there was no other protective film on the other
    side that I'd missed - there seems to be just the tape around the
    adhesive. When I restored it, the insert suddenly began to curl up at
    that edge, so I hastily stopped it (they warn about not bending the
    insert too tightly). Possibly that damaged it, but if so then they are extremely fragile and may not survive day-to-day usage.

    I've removed it to prevent it sticking firmly and writing off a brand
    new visor.
    --

    CHUMP #1 (CHarge Up Muppet)

    Pip

    --- Synchronet 3.22a-Linux NewsLink 1.2
  • From Mark Olson@olsonm@tiny.invalid to uk.rec.motorcycles on Sun Nov 1 18:12:22 2026
    From Newsgroup: uk.rec.motorcycles

    PipL <pip@nowhere.nul> wrote:
    Part the first.

    After patching the Guzzi's rear wheel last week, I noticed that it was
    still losing a pound or two per day, so I left it to the weekend to have
    a look.

    The pressure was down 10 psi.

    The patch wasn't leaking! The valve was tight. The metallic looking
    thing in the tread turned out to be a tiny pebble of no consequence.

    Unfortunately, there was another fucking hole barely 20 mm from the
    first. I think that two patches so close to each other means a new tyre.

    Part the second.

    As my visor is getting a little old and because the Pinlock insert,
    though it worked pretty well generally, never fully sealed and water
    would sometime trickle down inside it, plus in severe conditions it
    would fog between layers. It's also getting on a bit.

    On the spur of the moment, I ordered a Visin electric visor kit.

    Today I fitted it. I made sure the brand new visor I'd bought was the
    right one. I checked the insert against the controller - green lights. I read the instructions, watched the video, fitted the template carefully, practiced fitting the insert, fitted it and... the fucking controller
    shows a fault.

    The only possible thing I can think of is that just before fitting it, I carefully peeled a couple of inches of the inner protective film back to look through and check there was no other protective film on the other
    side that I'd missed - there seems to be just the tape around the
    adhesive. When I restored it, the insert suddenly began to curl up at
    that edge, so I hastily stopped it (they warn about not bending the
    insert too tightly). Possibly that damaged it, but if so then they are extremely fragile and may not survive day-to-day usage.

    I've removed it to prevent it sticking firmly and writing off a brand
    new visor.

    Hugz

    Sometimes, the universe seems dead set against you.

    Don't let it get you down.

    Could be worse, etc. etc.

    --- Synchronet 3.22a-Linux NewsLink 1.2
  • From Alan Lee@alan@darkroom.plus.com to uk.rec.motorcycles on Sun Nov 1 19:32:33 2026
    From Newsgroup: uk.rec.motorcycles

    On 01/11/2026 16:49, PipL wrote:
    the fucking controller shows a fault.

    Hey, it could be worse, you could have an electric bike.
    --- Synchronet 3.22a-Linux NewsLink 1.2
  • From PipL@pip@nowhere.nul to uk.rec.motorcycles on Sun Nov 1 21:50:58 2026
    From Newsgroup: uk.rec.motorcycles

    On 01/11/2026 19:32, Alan Lee wrote:
    On 01/11/2026 16:49, PipL wrote:
    the fucking controller shows a fault.

    Hey, it could be worse, you could have an electric bike.

    Hardy har-har!

    It has actually been behaving quite well of late. There, that's jinxed it.
    --

    CHUMP #1 (CHarge Up Muppet)

    Pip
    --- Synchronet 3.22a-Linux NewsLink 1.2
  • From YTC1@ytc1@ytc1.co.uk to uk.rec.motorcycles on Mon Nov 2 15:02:51 2026
    From Newsgroup: uk.rec.motorcycles

    On 01/11/2026 16:49, PipL wrote:
    <snip>
    On the spur of the moment, I ordered a Visin electric visor kit.

    Today

    A what?
    <googles>


    HFM!

    Thats a lot of money, for something else that needs to be charged
    up..... every 8 hours

    Would it not have been cheaper to adjust the Pinlock? Or buy a new visor+Pinlock?
    --
    Bruce Porter
    "The internet is a huge and diverse community but mainly friendly" http://ytc1.blogspot.co.uk/
    There *is* an alternative! http://www.openoffice.org/
    --- Synchronet 3.22a-Linux NewsLink 1.2
  • From PipL@pip@nowhere.nul to uk.rec.motorcycles on Mon Nov 2 22:43:33 2026
    From Newsgroup: uk.rec.motorcycles

    On 02/11/2026 15:02, YTC1 wrote:
    On 01/11/2026 16:49, PipL wrote:
    <snip>
    On the spur of the moment, I ordered a Visin electric visor kit.

    Today

    A what?
    <googles>


    HFM!

    Thats a lot of money, for something else that needs to be charged
    up..... every 8 hours

    Would it not have been cheaper to adjust the Pinlock? Or buy a new visor+Pinlock?

    I readjusted the Pinlock several times, removed, it, cleaned the visor surface, refitted it... always the same. It was just a poor fit. I gave
    up in the end. I have just recently adjusted the visor pivots so it
    seals a little better, which could have helped.

    Maybe just a new visor & Pinlock would have been the answer but Pinlock
    do have big warning messages saying not to use at night, which always
    vaguely worried me, though it's almost certainly just corporate
    arse-covering. Online opinion seems to be divided on whether they
    transmit legal amounts of light, though the internet being
    international, whose laws they might be talking about was not clear.

    8 hours is fine for me: that's more than a weeks' worth of commuting of
    a total of about 5 hours or less.
    --

    CHUMP #1 (CHarge Up Muppet)

    Pip
    --- Synchronet 3.22a-Linux NewsLink 1.2
  • From YTC1@ytc1@ytc1.co.uk to uk.rec.motorcycles on Tue Nov 3 09:57:24 2026
    From Newsgroup: uk.rec.motorcycles

    On 02/11/2026 22:43, PipL wrote:
    On 02/11/2026 15:02, YTC1 wrote:
    On 01/11/2026 16:49, PipL wrote:
    <snip>
    On the spur of the moment, I ordered a Visin electric visor kit.

    Today

    A what?
    <googles>


    HFM!

    Thats a lot of money, for something else that needs to be charged
    up..... every 8 hours

    Would it not have been cheaper to adjust the Pinlock? Or buy a new
    visor+Pinlock?

    I readjusted the Pinlock several times, removed, it, cleaned the visor surface, refitted it... always the same. It was just a poor fit. I gave
    up in the end. I have just recently adjusted the visor pivots so it
    seals a little better, which could have helped.

    Having just done mine, I feel I saved some money :-)

    Maybe just a new visor &-a Pinlock would have been the answer but Pinlock
    do have big warning messages saying not to use at night, which always

    Eh? Don't remember seeing that warning. FOr a tinted visor maybe, but clear?

    Just had a look at their website and nothing jumps out, lots of chatter
    on forums though.

    vaguely worried me, though it's almost certainly just corporate arse- covering. Online opinion seems to be divided on whether they transmit
    legal amounts of light, though the internet being international, whose
    laws they might be talking about was not clear.

    8 hours is fine for me: that's more than a weeks' worth of commuting of
    a total of about 5 hours or less.


    That can be 1 day of blood biking, or a trip on the French run
    --
    Bruce Porter
    "The internet is a huge and diverse community but mainly friendly" http://ytc1.blogspot.co.uk/
    There *is* an alternative! http://www.openoffice.org/
    --- Synchronet 3.22a-Linux NewsLink 1.2
  • From PipL@pip@nowhere.nul to uk.rec.motorcycles on Tue Nov 3 19:06:15 2026
    From Newsgroup: uk.rec.motorcycles

    On 03/11/2026 09:57, YTC1 wrote:
    On 02/11/2026 22:43, PipL wrote:
    Pinlock do have big warning messages saying not to use at night, which
    always

    Eh? Don't remember seeing that warning. FOr a tinted visor maybe, but
    clear?

    It was a clear one that came with the helmet.
    --

    CHUMP #1 (CHarge Up Muppet)

    Pip
    --- Synchronet 3.22a-Linux NewsLink 1.2
  • From YTC1@ytc1@ytc1.co.uk to uk.rec.motorcycles on Thu Nov 5 09:43:28 2026
    From Newsgroup: uk.rec.motorcycles

    On 03/11/2026 19:06, PipL wrote:
    On 03/11/2026 09:57, YTC1 wrote:
    On 02/11/2026 22:43, PipL wrote:
    Pinlock do have big warning messages saying not to use at night,
    which always

    Eh? Don't remember seeing that warning. FOr a tinted visor maybe, but
    clear?

    It was a clear one that came with the helmet.

    Next time I buy one. I'll have a look
    --
    Bruce Porter
    "The internet is a huge and diverse community but mainly friendly" http://ytc1.blogspot.co.uk/
    There *is* an alternative! http://www.openoffice.org/
    --- Synchronet 3.22a-Linux NewsLink 1.2