Before you say it TNP, carbody filler was my nextI have actually run out. A trip to Halfords is indicated
go to.
In July we moved into our bungalow. Built in the nineties it has concrete block internal walls, so far so good, fixing anything including heavy items to them should not be a problem. However, I have had to reposition a socket about to be obstructed by a built in wardrobe. Only when knocking out to
sink a 35mm deep back box I found the blocks were those with the vertical hollows and in no time at all the block was crumbling due to the hollows
not leaving much to fix the back box to.
In the past at our first house when we had a similar problem I just
chiselled out the thin bits left and using suitably sized wood blocks stuck in with the likes of rCLSticks like Sh*trCY provided a suitable back to fix a back box to. Today I used a thick mix of Tourpets Masonry Repair filler sqidged into the hole and squashed the back box in and it stuck in
position.
The only issue with both solutions is having to wait for the gunging
material to set before anything else could be done, so I would be
interested in anyone elserCOs solution particularly ones that would allow further work to proceed. Before you say it TNP, carbody filler was my next
go to.
(you can also get plaster accelerators like "half time" that you can sprinkle in as you mix - does what it says on the sachet (try that on
old bonding and it might actually go back in time!))
I used a thick mix of Tourpets Masonry Repair filler
sqidged into the hole and squashed the back box in and it stuck in
position.
The only issue with both solutions is having to wait for the gunging
material to set before anything else could be done
| Sysop: | Amessyroom |
|---|---|
| Location: | Fayetteville, NC |
| Users: | 76 |
| Nodes: | 6 (0 / 6) |
| Uptime: | 60:27:39 |
| Calls: | 1,265 |
| Calls today: | 1 |
| Files: | 1,362 |
| D/L today: |
4 files (9,632K bytes) |
| Messages: | 286,219 |