From Newsgroup: alt.os.linux.slackware

I had to ask.

Can I do it?

Duck AI says:

Yes, you can use SlackwarerCOs ARM/AArch64 project on a Jetson Nano,
because itrCOs an ARM (aarch64) device.

However, the key question is whether Slackware ARM/AArch64 has an image/ installer specifically for the Jetson NanorCOs hardware/boot setup (or at least the same storage/boot method) and whether your JetsonrCOs board
support (bootloader + firmware + kernel/drivers like WirCaFi/Bluetooth/GPU) are supported well enough.

From the project site, Slackware ARM/AArch64 is organized around hardware model support and provides installers/guides for specific hardware
models. slackware.com It also notes AArch64/ARMv8-a as the baseline for
the AArch64 dev branch, so the rCLarchitecture matchrCY is typically fine for Jetson Nano, but hardware-specific support is still the gating factor. slackware.com

Oh, S***. I'm too busy for this.

-Joe
--- Synchronet 3.22a-Linux NewsLink 1.2